Skip to main content

When an Inbox Is Disconnected: What Happens and How to Resume

An inbox can become unavailable either because you manually disconnect it from Salesgear or because the email provider revokes access. When this happens, Salesgear takes specific actions to prevent failed sends.


What happens immediately

  • No new emails are sent from that inbox

  • Contacts assigned to that inbox are paused automatically, unless automatic reassignment is on (see below)

  • The sequence's Configurations tab shows Inbox disconnected (or All inboxes disconnected) in the status panel, with a Reconnect button

  • You get an email telling you the inbox lost access


Automatic reassignment

If the sequence has Automatically reassign contacts if an inbox gets disconnected. turned on and another active inbox is in the sequence, contacts move to that inbox and keep going. This only works when the sequence has more than one inbox.


Impact on sequences

  • New sequences

    • If at least one inbox is connected, the default inbox is automatically added

    • If no inboxes are connected, the sequence will have no inbox assigned

  • Adding contacts to sequences

    • If a sequence has email steps but no active inbox, you'll see an error when adding contacts

    • Add an inbox under Configurations → Sending inboxes and retry


How to get contacts sending again

  1. Open the sequence, go to Configurations, and check the inbox is listed in Sending inboxes. Add it again with Add inbox if it was removed.

  2. Contacts in pending state that were marked failed automatically move back to pending.

  3. Resume the paused contacts (or the sequence).


Resuming contacts and paused sequences

Salesgear checks the inbox assigned to each contact before resuming.

  • Assigned inbox is active in the sequence: the contact resumes and scheduled emails continue as planned.

  • Assigned inbox is no longer available: the contact remains paused and no emails are sent. If you resume a single contact, you may see "Failed. Could not resume contact as the scheduled inbox is disconnected."

📌 To fix a contact that stays paused, reconnect the original inbox, or add another inbox and turn on automatic reassignment. This prevents emails from being sent from an unintended sender.

Did this answer your question?