Add a Deep Research step to a sequence and Salesgear researches each contact as they enter it, then writes the messages for every later step using that research. You can review each contact's messages before they go out, or let them schedule on their own.
š The Deep Research step is turned on per team. If you don't see Deep Research when you click Add Step, it isn't on for your team yet. Each new research uses 10 credits. You need a seller profile (see Set Up Your Seller Profile).
Step 1: Add the Deep Research step
Go to Sequences and open your sequence.
Click Add Step and choose Deep Research.
In Add Deep Research step, pick the Seller profile to write from.
Enter an Outreach goal, or pick one: Get a reply, Book a 15-min call, Drive to website, Demo signup or Event invite.
Set Reuse existing research if newer than (days). A contact researched within that many days reuses that research instead of running a new one (default 30).
Tick or untick Approve content before sending (see Step 2), then click Save step.
š A sequence can have one Deep Research step. Once it's added, the menu shows it as ā Added. To change its settings later, click the step and edit it.
Step 2: Choose approval or auto-pilot
Approve content before sending on: the step shows Approval required. After research, each contact waits with the status Awaiting approval until you review their messages. Nothing is scheduled until you approve.
Approve content before sending off: the step shows Auto-pilot. Messages are scheduled automatically, and you can still edit them before they send.
Step 3: Review and approve
Open the sequence. When contacts are waiting, a banner shows N contacts awaiting your approval. Click Review ā. (You can also click the Awaiting approval status on a contact in the Contacts tab.)
Read each message and the time it will send once approved. Click Edit to change one, then Save changes.
Click Regenerate all to rewrite every message for that contact in one go, or Show research to see what the messages are based on.
Click Approve all N messages to schedule them, or Reject contact to stop that contact in the sequence so none of the messages go out.
Use ā Prev and Next ā¶ to move between contacts.
š To stop a message that's already scheduled, click Cancel send on it.
What happens next
Approved contacts move on through the sequence like any other contact.
See credits used under More ā Settings ā Deep Research ā Usage.
