Skip to main content

Build Your Own Agent

Describe an agent in plain English or build it step by step: how it starts, steps, If yes / If no branches, and settings.

When no template fits, you can build your own agent. Describe it in plain English and Salesgear drafts the steps, or build it from scratch: choose how it starts, then add steps, waits and branches.

📌 You need Agents turned on for your team and room under your plan's agent limit. LinkedIn steps need a connected LinkedIn account, CRM steps need a connected CRM, and Slack messages need Slack connected. Steps marked Uses credits spend credits when they run.


👉 Describe it in plain English

  1. Go to Agents and click Hire an agent.

  2. In the box under Describe it. We'll build it., write what the agent should do. For example: "When a contact replies to an email, research them and create a follow-up task for me."

  3. Click Build it (or press ⌘↔). The builder opens with the steps filled in.

  4. Check the steps, then click Create agent.


👉 Build it from scratch

  1. On Hire an agent, click Build from scratch and type an Agent name.

  2. Next to When, click Change and pick how it starts:

    • From your Signals (then Which signal?)

    • When it happens in Salesgear (then What happens in Salesgear?, for example Contact replies to an email)

    • On a schedule (Runs, Time, Time zone)

    • When you run it

    Click Done.

  3. Click Add your first step. The first step says where the contacts or companies come from, for example From a contact list, From a saved search or Find people who match your ICP.

  4. Click Add a step to add more. Search, or filter by Find & enrich, Filter, Do, Tell me or Flow. Fill in each step's fields. Steps with missing fields are highlighted.

  5. Under Settings, set Contacts per run, Notify me (Daily digest, After every run, Only when a run fails, Off), Send it to and Slack channel, and Ask me before every run acts.

  6. Click Create agent. It's saved as a draft.

📌 Create agent greyed out? Name your agent, add at least one step, and fill in the highlighted steps.


👉 Add If yes / If no branches

  1. Click Add a step, choose Flow, then Split by condition.

  2. Set the rule. Choose Match ALL or ANY of these, and click + Add condition for more rules.

  3. Add steps under If yes and under If no. A path with no steps reads Nothing extra.

Other flow steps:

  • Route by cases: one path per case, plus If none of these. Add more with + Add case.

  • Split: replied vs no reply

  • Wait a while

  • Wait for a reply / event, with If it happened / If it didn't paths


What happens next

  • Your agent waits as a draft until you test and turn it on.

  • To change it later, open the agent and click Edit flow, or type in Describe a change (for example "Run on weekdays at 9am") and the steps update. Nothing is saved until you click Save changes.

  • For agents that start When you run it, some fields (like a LinkedIn URL) can be set to Ask each run.

Did this answer your question?