Skip to main content

LinkedIn Messages Wait for Connection Acceptance

Salesgear sends your LinkedIn messages only after a connection request is accepted, when your sequence is designed that way. You can only message 1st-degree connections, so waiting means fewer failed steps and cleaner sequences.


When Salesgear waits for connection acceptance

This is automatic. Salesgear waits only if:

  • A LinkedIn Connection Request step earlier in the same sequence was sent to this contact

  • The next step is a LinkedIn Message step (not InMail)

If the contact is already connected to you, the message step isn't held.


How it works

  1. The connection request goes out.

  2. When the contact reaches the message step and hasn't accepted yet, their status in the sequence's Contacts tab shows Waiting. Hover it to see "This contact is waiting for LinkedIn connection acceptance."

  3. Salesgear checks your LinkedIn connections regularly. Once the request is accepted, the contact goes back to active and the message is queued to send.


Handling multiple contacts with different acceptance times

Each contact is handled individually and moves on as soon as they accept.


What happens if the connection is not accepted

  • No message is sent

  • The contact stays in Waiting

  • You can remove the contact from the sequence or move them on yourself

📌 A Waiting contact doesn't use your daily message limit. Nothing is sent until they accept.


Key takeaways

  • Waiting applies only when a connection request was sent in the same sequence

  • No acceptance = no message

  • Already-connected contacts get the message without waiting

Did this answer your question?